In my opinion, underground water streams are the main reason for a low energy level in a house. Water can run as close as 1 meter from the surface, as common in Europe, to 350 meters deep and perhaps more. In certain places in Europe, one only needs to dig 3 to 4 meters and voila! Water is pumped out.
In Israel most streams are at a level of 50 to 350 meters below the surface. Still they affect us.

Why do streams bother our health? Taking streams flowing underground at a speed of more than 3 km/hr, the following phenomena occur:

1. A positive vertical electric field is created above the stream.
2. There is also a DC-generated, magnetic field.
3. The river flow generates radio frequency (RF) in the MHz range.
4. The sides (margins) of the river are about six cm wide. This is where most energy is concentrated.
5. The very middle of the river is also six cm wide.
6. Gamma rays from the cosmos are normally absorbed by sandy soil and dry earth. When encountering an underground stream or wet clay, the rays are reflected back up, to us.
7. Gamma radiation from the earth is increased. The gamma rays have an ionizing effect, causing an increase in free radicals. Free radicals cause changes in cell structure.
8. Infrared radiation is increased.

Locating Underground Streams

In order to neutralize the negative effects of an underground stream, one must approach it from both ends of the property or house.
Streams are identified using dowsing rods (L or Y rods). Start on one side of the property. When looking for water, one can walk fast, as the change in magnetic field is greater than with geopathic lines. Once discovered, the dowser returns over the area and identifies the first bank of the stream. This location is marked.
Then, coming from the opposite end, the second bank is identified and marked.
This is repeated for the second end of the property.

Blocking the Energy

Measure the distance between markers and locate the center. Drive a 40 to 50 cm steel rod (about 10 mm dia.) at the center of the stream. The rod is inserted 2 to 3 cm below ground. This action shorts out the energy between the ground layers and neutralizes negative energy between the rods. I have seen the energy of a house go up (on the Bovis scale), as the rod was being inserted.

Working with Nature

Thirteen thousand years ago, Atlantis sunk into the abyss of the ocean. With it, sank man’s consciousness.
Part of the reason given for the fall of Atlantis was the abuse of Nature Spirits. In the ancient days, there was close cooperation between man and the forces of Nature, and those forces used to comply to just about any request made by the Atlanteans. Thus, the use, over use and abuse.

Only recently was the connection remade between the two parties. Today, anyone can request and cooperate with the forces of nature, in order to clear negative energies. It’s true and it works. I do it all the time. How and what do we do?

The Negative Parameters

Negative parameters are categorized into two areas: those which can be dealt physically and those which can only be taken care of spiritually.

Physical Treatment

Specifically, about the physical treatment of pathogenic electromagnetic networks (Hartmann and Curry): those can be handled by blocking the lines individually, as they enter the property (Physical Blocking of Geopathic Lines). I do this sometimes, in special cases and for limited locations, but usually I ask Nature to convert the lines from negative to positive.
Also, underground water can be taken care of by physical means (Handling Underground Water Streams), by neutralizing each stream, one at a time. The effect is instantaneous and amazing.

Spiritual Handling

Looking at a long list of negative parameters which we usually check during a house clearing, we have:
Pathogenic networks: Hartmann, Curry, Wissman, etc…
Green energy: caused by all of the electronic equipment in the house.
Black energy: the spooky stuff (voodoo, black magic, curses…).
Spiritual energy: anger, jealousy, hate.
Trapped spirits: someone in your house that does not belong there.
Electromagnetic energy: from power transformers.
Energy in walls: walls collect all energy, negative and positive.
and others….

The Negative Parameters

The above are handled by a ceremony which calls upon noble and good entities, angels and the world of nature spirits and the elements. The ceremony includes a number of steps:

• Calling a number of entities (angels, mother Earth, etc…)
• Gathering of all negative energies and sending them up and away
• Having pathogenic lines transformed from negative to positive
• Clearing the space above the property
• Releasing all trapped spirits
• Thanking all.

Forces of Nature

There are two types of Nature forces:

Devas: these are architects of Nature. They supervise the workers of nature, the form builders, known as the Elementals. Devas appear at all levels. They are intelligent energy. Thus, we can have a Deva for an apartment, another Deva for the entire building, one for the neighborhood and one for the whole city.
Elementals: Elementals are the intelligent essence of consciousness, working with the physical side of Nature (such as seeds, eggs, etc..), in order to have all living things develop.

Introduction

This tutorial explains how geopathic stress lines are located and blocked. The lines are Hartmann and Curry lines, from the respective networks. The blockage is done using metal rods or omega-shaped copper wire or L-shaped metal rods. The blockage can be done outside the property, if surrounded by grass, or inside an apartment, along floor panels. The effect is the same.
In this tutorial, it is taken for granted that the dowser knows about the different networks and is capable of handling dowsing instruments.

A Reminder

The electromagnetic networks are caused by a great metal core in the center of the earth. Rotation of this core, generates electromagnetic networks. The networks are many, some beneficial, some neutral and some harmful. We will block the harmful ones, namely: Hartmann and Curry.
Hartmann runs S-N and W-E while the Curry network is at 45 to the Hartmann network.
Remember that there is a direction of flow to the lines:

• Hartmann lines flow from West to East and South to North.
• Curry lines originate in the North and take a southern direction at 45, pretty much like an X.

Some General Guidelines

• To block lines, no matter the system used, the blockage must be done at 90 to the line and as close as possible to the center. That is where there is the most energy. Precision counts, as the Hartmann lines are 21 cm wide, with a 2 cm center, whereas the Curry lines can reach up to 50 cm width.
• Check the line presence prior to and after the blockage to insure full efficiency.
• If the line is not in parallel with the walls of the room, locate the blocking means, over the center of the line and recheck for blockage. Carefully move the block, until the line is no longer present when dowsing for it.
• Use parallel [L-rods] when first starting out or even as routine checks for seasoned dowsers. These rods are very sensitive and accurate.

Working Outside, in the Garden

If the home is surrounded by a garden, then the work is done outside. Identify directions (North) and start to locate the networks, each at a time. Stake each line with a marker (use wooden or metal stakes, with different colored ribbons).
Then, at each location, dig a small and narrow trench, at ninety degrees to the line. Make sure that you observe the direction of flow, otherwise you will be blocking lines for the neighbor. The trench is to be about 30 cm long and 5 cm wide. Dig to a depth of about 10 cm.
You can use thin metal rods, the type used for welding, or building steel, about 3 to 6 mm in diameter.
The rods are bent and inserted, as shown in the following figures.

Metal Rod Fabrication

1. Insert the long side of the rod, at about a 30-degree angle, into the trench (1). Then, push the rod into the ground so as to be flat in the trench (2).

Inserting the First Rod

2. Take another rod and do the same from the opposite end.

Inserting the Second Rod

3. This is how it looks, when done.

Done!

4. Cover the trench with earth.

blocking Lines Inside the House

Many people live in apartment buildings. Lines are then blocked in the rooms themselves. Two types of metal means are used for this purpose:

1. Thin metal rods, as described above. These are steel, copper-plated 2.5 to 3 mm diameter rods, used for gaz welding. I use 50 cm lengths.
2. Omega, made of electric copper wire, 12 AWG and cut to the exact length of a cubit (52.4 cm). It is better if the wire is insulated, so as not to turn green.

1. 
   Omega Block

Whether you elect to use metal rods or omega blocks, depending on the availability of materials, the technique to be used is similar.

In each room identify the directions (North, etc…). According to the direction of flow of the type of line, identify the wall to follow in the apartment. Locate the Hartmann and Curry lines and label the locations. Use the blocking means selected and place it over the line center. See the figures hereafter.

For metal rods: place the rod behind carpet pals, under wooden panels running along the walls, on the floor. This will hide the rods from view and prevent them from being moved inadvertently. As an alternate method, lay the metal rod along the junction of the floor tiles and the wall panels. Secure in place with Scotch tape.
For omega blocks: lay the omega, touching the floor, across the line (riding on the line) and tape to the wall.

Blocking Lines Using Metal Rods

Blocking Lines Using an Omega